|
[Sponsors] |
April 29, 2014, 05:48 |
References for the VdjModel in settlingFoam?
|
#1 |
Member
X Meng
Join Date: Jun 2012
Location: Scotland
Posts: 89
Rep Power: 13 |
Hi guys,
Can anyone tell where I may find the reference for the 'general' and 'simple' models for Vdj in solver 'settlingFoam'? Really appreciate. Thanks. |
|
May 15, 2014, 10:49 |
|
#2 |
Senior Member
Santiago Marquez Damian
Join Date: Aug 2009
Location: Santa Fe, Santa Fe, Argentina
Posts: 452
Rep Power: 23 |
Hi, check the Brennan's and Bohorquez's theses.
Regards.
__________________
Santiago MÁRQUEZ DAMIÁN, Ph.D. Research Scientist Research Center for Computational Methods (CIMEC) - CONICET/UNL Tel: 54-342-4511594 Int. 7032 Colectora Ruta Nac. 168 / Paraje El Pozo (3000) Santa Fe - Argentina. http://www.cimec.org.ar |
|
January 6, 2015, 06:26 |
|
#3 |
Member
Jeremy Dudley
Join Date: Jul 2010
Posts: 45
Rep Power: 15 |
The 'simple' model is the Vesilind model.
The 'general' model is the Takacs model. The standard version of these models publishes coefficients for suspended solids measured in mass units, typically mg/l, sometimes g/l. settlingFoam uses volumetric fraction, so you need to convert. volumetric fraction x solids density should be good enough |
|
January 23, 2015, 12:14 |
|
#4 |
Member
X Meng
Join Date: Jun 2012
Location: Scotland
Posts: 89
Rep Power: 13 |
Thank you so much for above two answers, really helpful!
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
settlingFoam crash when velocity increase | jimbean | OpenFOAM Running, Solving & CFD | 1 | March 26, 2014 03:59 |
How to add Exner equation in settlingFoam | jimbean | OpenFOAM Running, Solving & CFD | 1 | October 6, 2013 09:59 |
Unrealistic pressure drop in settlingFoam | jochemvandenbosch | OpenFOAM Running, Solving & CFD | 1 | February 2, 2012 04:56 |
transportProperties settlingFoam | jochemvandenbosch | OpenFOAM Running, Solving & CFD | 3 | December 23, 2011 07:44 |
Diffrence in SettlingFoam 1.5 & 1.6 | pramodopen4foam | OpenFOAM | 0 | November 6, 2009 05:15 |