 |
 |
 |
|
|
|
[Sponsors] | ||||
October 30, 2019, 04:19
|
Creating a gemotry using blockMesh dict
|
#1 |
|
New Member
Deepanker Chaudhary
Join Date: Oct 2019
Location: France
Posts: 7
Rep Power: 6  |
hi everyone,
I want to a simulation of air entroanment in the visocus pool by using 2 cylinder which are to be rotated in the opposite direction. No flow across the doamin is taking place. also i want to create a rotating cylinder boundary conditon. For this i am thinking of using interfoam as my solver. As you can see in the image attached, there are lots of blocks, is this the most efficient way of doing it ? Is there any way to use symmetry command or something like this so that i just need to write vertices for just left half and the right half of my domain gets dicretised automatically ? Looking forward for any help regards, Deepanker https://www.dropbox.com/s/0ya1mu0znk...70%29.png?dl=0 https://www.dropbox.com/s/bsswutb3en...4.31.jpeg?dl=0 Last edited by ShanuNith; October 30, 2019 at 09:27. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [blockMesh] Wierd behaviour of blockMesh creating axis in wedge | rcastilla | OpenFOAM Meshing & Mesh Conversion | 1 | December 4, 2018 06:24 |
| [blockMesh] Segmentation Fault when creating block mesh topography (blockMesh) | jbrydg01 | OpenFOAM Meshing & Mesh Conversion | 2 | May 11, 2017 05:37 |
| [blockMesh] Error while creating blockMesh: Inconsistent point locations between block pair | lpashwin | OpenFOAM Meshing & Mesh Conversion | 2 | June 1, 2015 12:31 |
| [blockMesh] Error while running blockMesh | Harak | OpenFOAM Meshing & Mesh Conversion | 0 | December 11, 2014 09:36 |
| Possible Bug in pimpleFoam (or createPatch) (or fluent3DMeshToFoam) | cfdonline2mohsen | OpenFOAM | 3 | October 21, 2013 09:28 |
Linear Mode
