|
[Sponsors] |
July 17, 2016, 10:10 |
surface sampling during simulation run
|
#1 |
New Member
mohafarmani
Join Date: Aug 2015
Location: shiraz
Posts: 14
Rep Power: 10 |
Hi Foamers,
I am beginner in OF. I want to run a big case and need to save U-mean over some surfaces located in the doamin during simulation, in every time steps. If i don't want to save fields every time steps and just want to save some fields over some specified surfaces during simulation run, how can i do it? Any hint is appreciated. Regards, Mohammad |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
surface sampling to CGNS | wcpvandervelden | OpenFOAM Post-Processing | 0 | April 28, 2014 12:16 |
surface sampling with a step smaller than outputTime | seiji_adachi | OpenFOAM | 3 | April 15, 2014 04:44 |
Simulation of varying contact angles for a large droplet of water on a surface | cp703 | CFX | 5 | July 20, 2013 06:08 |
[ICEM] Automatic mesh generation script surface intersection problem | stuart23 | ANSYS Meshing & Geometry | 0 | May 13, 2011 01:10 |
Procedure to run unsteady simulation? | STN | Main CFD Forum | 2 | February 16, 2002 04:37 |