|
[Sponsors] |
November 20, 2020, 09:11 |
dynamicMesh morphing pipe
|
#1 |
New Member
ROIN bin
Join Date: Dec 2019
Posts: 11
Rep Power: 6 |
When I use the morphing mesh, since the model is inside a pipe, the calculation field is very small and the motion of the objects sometimes comes very close to the wall, which causes the mesh to deform a lot and the calculation collapses. Do you have any good suggestions for me?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[DesignModeler] DesignModeler Pipe within pipe | shields | ANSYS Meshing & Geometry | 13 | November 25, 2018 22:14 |
need help about double pipe heat exchanger with chtMultiRegionSimpleFoam | wuyangzhen | OpenFOAM | 10 | December 12, 2017 00:19 |
Double Walled Pipe Boundary | dahvqaz | FLUENT | 2 | December 5, 2012 10:14 |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |
fluid flow fundas | ram | Main CFD Forum | 5 | June 17, 2000 21:31 |