|
[Sponsors] |
April 15, 2010, 06:14 |
Read Mesh
|
#1 |
New Member
Peter Wiemeyer
Join Date: Sep 2009
Location: Germany, Munich
Posts: 22
Rep Power: 17 |
Hello all,
I got some experiences with OpenFOAM within the last two years and now the next step for me would be to get a little bit more introduced to the development. What I can contribute in future to the community is not clear at the moment it's dependet on my employer but to contribute something there has to be something first and so I will try to write my first program. In snappyHexMesh it's always a problem when there're small holes somewhere. To find them is quite a horrible task. Some time before I wrote a program that understood the mesh format of OpenFOAM and analyzed a path from one specified point to another in the mesh with the target to find a path => a hole could be find more or less easily. A program like this is the same reinventing a wheel new, because I'm sure it is easy, to read in a mesh with existing OpenFOAM routines and getting the information of all face numbers from one specified cell is as easy as getting max cell numbers, face numbers etc. Can perhaps someone give me some hints where to get the information that I need or even better give me the information directly? Thx & best Regards Peter Wiemeyer |
|
Tags |
cells, faces, import, mesh, points |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] vtk mesh or Abaqus mesh to OpenFOAM | bigphil | OpenFOAM Meshing & Mesh Conversion | 27 | November 23, 2015 18:31 |
[ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 01:27 |
[mesh manipulation] TranformPoints gives skewed mesh Possible Bug | andersking | OpenFOAM Meshing & Mesh Conversion | 3 | March 25, 2008 22:33 |
basic of mesh refinement | arya | CFX | 4 | June 19, 2007 13:21 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 19:10 |