|
[Sponsors] |
August 29, 2012, 07:54 |
cyclicAMI for non matching geometry?
|
#1 |
New Member
Thomas
Join Date: Aug 2012
Posts: 5
Rep Power: 13 |
Hello Foamers
If I am not mistaken cyclicAMI can be used to make two independently meshed and moving areas interact with each other. (As seen in the ship's propeller tutorial) My question: Is it possible to connect two meshes which do not match geometrically? E.g. consider two boxes on top of each other. The upper one like three times the size of the lower one and sliding on top of it. Any help/comment/discussion would be greatly appreciated. Best, Thomas |
|
Tags |
cyclic boundary, moving mesh |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem Importing Geometry ProE to CFX | fatb0y | CFX | 3 | January 14, 2012 19:42 |
[DesignModeler] Error while Loading a Geometry | JD944 | ANSYS Meshing & Geometry | 0 | October 25, 2011 14:51 |
[Gmsh] Problem meshing an imported geometry | Alicia | OpenFOAM Meshing & Mesh Conversion | 0 | March 30, 2010 04:53 |
Simulation of Flow through Complex 3D Geometry | EmersonKB | CFX | 5 | July 2, 2009 08:17 |
vitual _ real | deneb | FLUENT | 3 | January 22, 2007 04:31 |