|
[Sponsors] |
February 12, 2013, 04:38 |
Running without wall function
|
#1 |
Member
Simone
Join Date: Sep 2012
Posts: 95
Rep Power: 13 |
Hi to everyone! I'd like to run a case without wall function and the Spalart-Allmaras turbulence model. Searching around I didn't really figured out what to do regarding the boundary condition on the solid body for nut and nuTilda. I suppose this setting:
nut: solidBody { type nutLowReWallFunction; value uniform 0; } nuTilda: solidBody { type fixedValue; value uniform 0; } Am I correct or should I use also fixedValue for nut? Any answer is really, really appreciated! Cheers Simone |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
foamToTecplot360 | thomasduerr | OpenFOAM Post-Processing | 121 | June 11, 2021 10:05 |
Enhanced Wall Treatment | paduchev | FLUENT | 24 | January 8, 2018 11:55 |
Radiation interface | hinca | CFX | 15 | January 26, 2014 17:11 |
channelFoam for a 3D pipe | AlmostSurelyRob | OpenFOAM | 3 | June 24, 2011 13:06 |
Need some wall function approaches! | yka8150 | Main CFD Forum | 0 | September 21, 2009 23:08 |