|
[Sponsors] |
September 3, 2013, 11:30 |
|
#13 |
Senior Member
Ehsan
Join Date: Oct 2012
Location: Iran
Posts: 2,208
Rep Power: 26 |
but if I make mesh finer near wall its y+ will be too low,I want it be more than 30 till I have a high Re mesh.
edit: yplus turns below 30 in many snapshot times like the attached one,so I use mutUSpaldingWallFunction that someone said to me that its fine for these situations,is it OK in your opinion?
__________________
Injustice Anywhere is a Threat for Justice Everywhere.Martin Luther King. To Be or Not To Be,Thats the Question! The Only Stupid Question Is the One that Goes Unasked. Last edited by wyldckat; September 4, 2013 at 16:19. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
OpenFOAM - Validation of Results | Ahmed | OpenFOAM Running, Solving & CFD | 10 | May 13, 2018 18:28 |
lid driven cavity varying results | yasmil | OpenFOAM Running, Solving & CFD | 2 | October 6, 2016 21:42 |
CFD results not close to experimental results | cider | STAR-CCM+ | 0 | July 8, 2013 07:53 |
Different Results from Fluent 5.5 and Fluent 6.0 | Rajeev Kumar Singh | FLUENT | 6 | December 19, 2010 11:33 |
Airfoil y+ Results Query | asd | Main CFD Forum | 1 | June 22, 2007 08:02 |