|
[Sponsors] |
December 17, 2015, 19:34 |
OpenFOAM-2.4 mapFields error
|
#1 |
New Member
Qi Wang
Join Date: Dec 2015
Posts: 2
Rep Power: 0 |
Hi,
I am new to OpenFOAM and having a problem using "mapFields" application. The application was run like: ---------------------------- mapFields ../Inflow/example -sourceTime 17000 -mapMethod mapNearest > log.mapFields 2>&1 ---------------------------- Since at 17000, I changed the mesh and want to start a new analysis from there. However, according to the log file, the "Source Time" is set to 0, see below. ----- Source time: 0 Target time: 17000 ----- Any ideas? Thanks! |
|
December 18, 2015, 02:26 |
|
#2 |
Senior Member
Anton Kidess
Join Date: May 2009
Location: Germany
Posts: 1,377
Rep Power: 29 |
Is there a folder 17000 in ../Inflow/example ?
__________________
*On twitter @akidTwit *Spend as much time formulating your questions as you expect people to spend on their answer. |
|
December 18, 2015, 18:53 |
|
#3 |
New Member
Qi Wang
Join Date: Dec 2015
Posts: 2
Rep Power: 0 |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Building OpenFOAM1.7.0 from source | ata | OpenFOAM Installation | 46 | March 6, 2022 13:21 |
Pressure outlet boundary condition | rolando | OpenFOAM Running, Solving & CFD | 62 | September 18, 2017 06:45 |
Mesquite - Adaptive mesh refinement / coarsening? | philippose | OpenFOAM Running, Solving & CFD | 94 | January 27, 2016 09:40 |
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
Problem with compile the setParabolicInlet | ivanyao | OpenFOAM Running, Solving & CFD | 6 | September 5, 2008 20:50 |