[Jörg]

Hi Fomler,

I must simulate a convection oven for my bachelor work with OpenFoam.
I'm more or less beginners with CFD.

My current problem lies in the selection of the solver, and the settings of the boundary conditions.
My blockMesh is running ok.
I have to look for the flow in the oven.

There a 4 inlets at the Top and 4 at the bottom. It will stream in the inside of the oven and go out about excess pressure right and left of the oven.

I have do in the Attachmants my zip.
Maybe can someone look at this and give me some help.

her now the current fault.


Create time
Create mesh for time = 0
Reading field p
Reading field U
Reading/calculating face flux field phi
Selecting incompressible transport model Newtonian
Selecting turbulence model type LESModel
Selecting LES turbulence model oneEqEddy
Selecting LES delta type cubeRootVol
　
--> FOAM FATAL ERROR:
Case is not 3D or 2D, LES is not applicable
From function cubeRootVolDelta::calcDelta()
in file cubeRootVolDelta/cubeRootVolDelta.C at line 72.


Best regards,
Jörg

[Jörg]

the blockMeshDict