|
[Sponsors] |
October 27, 2017, 08:28 |
wmUNSET works for 2.4.0 but not for 5.0
|
#1 |
Senior Member
Deep
Join Date: Oct 2017
Posts: 180
Rep Power: 8 |
Hello!
Minor issue: the wmUNSET command works while I'm running the 2.4.0 version but if I change to OF 5.0, it says Code:
wmUNSET: command not found Anyone knows what could be going wrong ? |
|
October 29, 2017, 07:20 |
|
#2 | |
New Member
Chris Coutinho
Join Date: Jan 2015
Location: Netherlands
Posts: 28
Rep Power: 11 |
Quote:
Close your terminal and reopen it to use another version of OpenFOAM. |
||
October 30, 2017, 07:00 |
|
#3 | |
Senior Member
Deep
Join Date: Oct 2017
Posts: 180
Rep Power: 8 |
Quote:
But still, why won't it work for OF5.0 then ? Why the error |
||
October 30, 2017, 08:00 |
|
#4 |
Senior Member
|
Hi,
It was renamed. Here's OpenFOAM-2.4.x/etc/config/aliases.sh Code:
# clear env alias wmUNSET='. $WM_PROJECT_DIR/etc/config/unset.sh' Code:
# Clear env alias wmUnset='. $WM_PROJECT_DIR/etc/config.sh/unset' |
|
October 30, 2017, 12:38 |
|
#5 |
Senior Member
Deep
Join Date: Oct 2017
Posts: 180
Rep Power: 8 |
Thanks! That's exactly what I wanted to know.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error while importing Solid Works Model into Star CCM | Sandy7 | STAR-CCM+ | 3 | December 19, 2016 11:21 |
The costume code works in serial mode but not in parallel | ehsan_am86 | OpenFOAM Bugs | 1 | June 7, 2016 12:09 |
Parallel runs with sonicDyMFoam crashes (works fine with sonicFoam) | jnilsson | OpenFOAM Running, Solving & CFD | 0 | March 9, 2012 06:45 |
importing from Solid Works | andrew hayes | FLUENT | 3 | August 28, 2007 13:58 |
Importing from Solid Works | mettler | FLUENT | 1 | March 5, 2005 23:45 |