Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Running, Solving & CFD

low reynolds settings for kOmega and kEpsilon turbulence models

Mark Forums Read

Reply

Search this Thread

November 14, 2018, 16:29	low reynolds settings for kOmega and kEpsilon turbulence models	#1
emjay New Member Marko Josic Join Date: Dec 2010 Posts: 20 Rep Power: 16	hello community, may someone have a short and correct answer howto set up the wall boundary conditions for walls with an full resolved mesh (y+ ~1 / low reynolds approach). (case is also incompressible) kOmegaSST model for walls: U -> noSlip p -> zeroGradient k -> fixedValue (0 or 1e-12) omega -> ??? nut -> calculated? kEpsilon model for walls: U -> noSlip p -> zeroGradient k -> fixedValue (0 or 1e-12) epsilon -> ??? nut -> calculated? thank you in advance!

Reply

Tags

full resolved mesh, kepsilon, komegasst, lowre

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
PANS turbulence models	HelioVillanueva	OpenFOAM Programming & Development	39	June 23, 2024 08:13
Validation of homogeneous turbulence with constant shear for RANS models	GeorgS	OpenFOAM Running, Solving & CFD	2	August 30, 2018 16:11
[Contribution] Implementation of three turbulence models in openFoam	Ardali	OpenFOAM Programming & Development	0	August 25, 2015 04:23
Calculation of initial k for RAS turbulence models	shipman	OpenFOAM	1	August 28, 2013 04:52
KOmega Turbulence model from wwwopenFOAMWikinet	philippose	OpenFOAM Running, Solving & CFD	30	August 4, 2010 11:26

All times are GMT -4. The time now is 13:45.