|
[Sponsors] |
October 21, 2020, 08:14 |
CyclicAMI & SimpleFoam results residuals =1
|
#1 |
New Member
Konstantinos Polyzos
Join Date: Aug 2020
Posts: 2
Rep Power: 0 |
Hello,
I am trying to conduct a DDES simulation of an SUV with fully detailed rims. In order to set rotation to the rims during the transient simulation, I must add CyclicAMI faces that will split the stationary from the moving volume , and will allow the communication of the interior with exterior volume and vice-versa. I would like to start the transient simulation from a converged steady state one. However, the steady state simulation with cyclicAMI faces at the rims results in residuals near to 1. Could anyone give me any advice on that ? |
|
Tags |
cycli ami, moving mesh, openfoam 1.7.x, rotating rims, sliding mesh |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
simpleFoam - wrong results? | Zibi | OpenFOAM Running, Solving & CFD | 26 | October 9, 2020 13:21 |
time step continuity problem in VAWT simulation | lpz_michele | OpenFOAM Running, Solving & CFD | 5 | February 22, 2018 20:50 |
SimpleFOAM results way off from measurements and analytical calculation | Deagle | OpenFOAM Running, Solving & CFD | 1 | December 14, 2016 04:07 |
SimpleFoam results as initial condition to rhoSimpleFoam | marcelorl | OpenFOAM Pre-Processing | 5 | March 7, 2014 11:08 |
Weird results k-epsilon with simpleFoam | Alfalfa | OpenFOAM Running, Solving & CFD | 10 | January 24, 2014 19:05 |