|
[Sponsors] |
janafThermo warnings with ICE RCCI combustion simulation |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 9, 2020, 10:05 |
janafThermo warnings with ICE RCCI combustion simulation
|
#1 |
New Member
Join Date: Nov 2020
Posts: 1
Rep Power: 0 |
Hello,
I have a question regarding multiple warnings I'm receiving during my OpenFOAM simulations. I constantly encounter FOAM Warnings about janafThermo being out of temperature range (so temperature being below 300 [K]). A little background on my project. I'm trying to simulate RCCI combustion within an ICE, using IC8H18 as a low reactive PFI fuel and NC12H26 as a high reactive DI fuel. This engine is simulated from crankangle -153 aTDC till 150 aTDC. For the boundary conditions at crankangle -153 I used GT-Power to determine the conditions like pressure, temperature etc. The solver which I'm using to simulate is a solver from the LibICE library, called TDACCCMdieselEngineDyMFoam. Everytime I run my case I get these janafThermo warnings and after a while the simulations stops with errors. I tried different cases using different boundary conditions, but still the temperature diverges beyond the temperature range. I also tried reducing my time step for the simulation, still the same problem. I was wondering if anyone could help me out ? I'm fairly new to OpenFOAM as this is my first time working with OF. Thanks |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Constant Volume Combustion Chamber Simulation | sTeF88 | CONVERGE | 6 | October 24, 2024 06:50 |
thermal regeration of diesel particle filter (fixed bed combustion simulation) | Weiqiang Liu | FLUENT | 0 | April 22, 2020 10:57 |
Challenges in ICE Combustion Message Interpretation and Possible Solution Provision | ELITECHNIST | ANSYS | 0 | February 18, 2019 20:13 |
Liquid Fuel Combustion Simulation - need some guidance | sa007057 | FLUENT | 0 | September 15, 2014 14:57 |
ice melting simulation | pratikmehta | ANSYS | 3 | April 17, 2013 10:52 |