 |
 |
 |
|
|
|
[Sponsors] | ||||
March 2, 2021, 10:46
|
Very small timesteps using adjusttimestep
|
#1 |
|
New Member
Anirudh
Join Date: Feb 2021
Posts: 8
Rep Power: 6  |
I am validating a case on cavitation around 2d clark-y airfoil using interPhaseChangeFoam. maxCo=0.45 and timestep= 2e-05 as mentioned in the paper and by using adjusttimestep the simulation runs at 6e-09 timestep which is extremely small. I think there is some problem with mesh or boundary conditions. Kindly let me know if any particular file is required(p,u,transportproperties,etc). I have employed les, vof andkunz model for my sim.
Thank you. |
|
|
|
|
 |
| Tags |
| cavitation model, hydrofoil cavitation, interphasechangefoam, les model, vof multiphase |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| patch a small field in flow | wu yu | FLUENT | 5 | April 9, 2014 17:45 |
| small numerical fluctuations in the solution | nandiganavishal | OpenFOAM Running, Solving & CFD | 4 | June 18, 2013 04:01 |
| adjusttimestep led to extremely small timestep | kkpal | OpenFOAM | 2 | May 28, 2013 08:50 |
| [GAMBIT] Error: small gap in meshing with Tgrid | gdebadrawada | ANSYS Meshing & Geometry | 1 | April 19, 2013 05:21 |
| why did Time step is too small in stiffbs? | satum | FLUENT | 1 | December 10, 2012 10:15 |
Linear Mode
