|
[Sponsors] |
How can I use porous media with rhoPimpleFoam in Openfoam v1912? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 27, 2021, 16:52 |
How can I use porous media with rhoPimpleFoam in Openfoam v1912?
|
#1 |
New Member
Ali Can
Join Date: Apr 2021
Posts: 28
Rep Power: 5 |
I have been studying csvity flow problem and I would like to define porous surface aft wall of the csvity? Any suggestions??
Thanks in advance.. |
|
November 28, 2021, 11:01 |
|
#2 |
Senior Member
Yann
Join Date: Apr 2012
Location: France
Posts: 1,086
Rep Power: 26 |
Hi,
Porous media are usually defined using the explicitPorositySource in fvOptions. You first need to define a cellZone corresponding to your porous media volume. Here is tutorial using it with rhoPimpleFoam : angledDuctLTS Yann |
|
November 28, 2021, 13:01 |
|
#3 |
New Member
Ali Can
Join Date: Apr 2021
Posts: 28
Rep Power: 5 |
Thank you very much for your answer, it was very helpful.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Frequently Asked Questions about Installing OpenFOAM | wyldckat | OpenFOAM Installation | 3 | November 14, 2023 11:58 |
OpenFOAM simulation for packed bed porous media. | Ash Kot | OpenFOAM Running, Solving & CFD | 2 | March 18, 2021 06:57 |
OpenFOAM course for beginners | Jibran | OpenFOAM Announcements from Other Sources | 2 | November 4, 2019 08:51 |
How to set mixed-wet conditions in two-dimensional porous media in OpenFOAM? | xiaolianwei | OpenFOAM Pre-Processing | 0 | August 21, 2019 23:19 |
How to contribute to the community of OpenFOAM users and to the OpenFOAM technology | wyldckat | OpenFOAM | 17 | November 10, 2017 15:54 |