 |
 |
 |
|
|
|
[Sponsors] | ||||
June 30, 2022, 09:58
|
Tips on running cases with interFoam
|
#1 |
|
New Member
Join Date: Jun 2022
Posts: 19
Rep Power: 3  |
Hello Foamers,
I have just started using interFoam. I have some questions I would appreciate some help with. 1. When running cases with interFoam using the pimple algorithm with momentum predictor active, can I use relaxationFactors? Will they distort the physics if used? 2. In some of may test cases, the simulations diverge in the first time step. However, if I use setFields to fill the first layer of cells near the inlet, the simulation runs smoothly until the end. Is this a valid approach? |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| InterFoam stops after deltaT goes to 1e14 | francesco_b | OpenFOAM Running, Solving & CFD | 9 | July 25, 2020 06:36 |
| Help with running many cases of OF to generate training data for machine learning | quarkz | OpenFOAM Pre-Processing | 4 | September 12, 2019 08:01 |
| running interFoam on unstructured mixed elements | andrei.cimpoeru | OpenFOAM Running, Solving & CFD | 2 | August 22, 2016 03:40 |
| Problem in running tutorial cases | preetham | OpenFOAM Installation | 2 | June 13, 2009 16:36 |
| Kubuntu uses dash breaks All scripts in tutorials | platopus | OpenFOAM Bugs | 8 | April 15, 2008 07:52 |
Linear Mode
