[wjchoi]

hello!

i am beginner of openfoam.

when i studied case of the gas injection in water, i had a question..

there are three inlets, and i applied to the named selection of three inlets equally with each other as "inlet"

three inlets are separated each other, and the shape of three inlets are all circular shape, and the diameter is all same each other.

if i want to releaseing the gas as 3 m/s in total, how i have to set the boundary condition of inlet? (1) is right? (2) is right?


(1)
boundaryField
{
inlet
{
type fixedValue;
value uniform (0 3 0);
}


--> is this right?

(2)
boundaryField
{
inlet
{
type fixedValue;
value uniform (0 1 0);
}

--> is this right?

Thank you very much

[wjchoi]

[QUOTE=wjchoi;833698]hello!

i am beginner of openfoam.

when i studied case of the gas injection in water, i had a question..