Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Running, Solving & CFD

PotentialFoam fails

Mark Forums Read

Reply

Search this Thread

April 17, 2009, 10:43	PotentialFoam fails	#1
bastil Senior Member BastiL Join Date: Mar 2009 Posts: 530 Rep Power: 20	Dear all, just a scream of a hopeless guy ;-)... I had a case running some time ago and now try to run a very similar one. I am failing in getting an resonable start solution from potentialFoam, I get exploding velocities at sharp corners around the stagnation point. No idea why this happens, similar cases ran fine. PotentialFoam takes all the allowed pressure steps (100) whereas for similar cases before he took about 50. An idea? Regards.

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Using potentialFoam with simpleBuoyantFoam	lasb	OpenFOAM Running, Solving & CFD	5	August 28, 2015 13:32
PotentialFOAM for channel flow	albcem	OpenFOAM Running, Solving & CFD	0	October 16, 2008 13:18
CFX FAQ updated - my simulation fails to converge	Glenn Horrocks	CFX	0	September 1, 2007 08:33
fails saying “small gaps”	Neser	FLUENT	2	February 2, 2004 21:16
SOR Fails Near Walls	Chih-Wei Chiu	Main CFD Forum	0	May 9, 2002 02:05

All times are GMT -4. The time now is 10:26.