|
[Sponsors] |
October 25, 2015, 14:58 |
OpenFOAM Aircraft dynamic meshing
|
#1 |
Senior Member
|
Hello Every one,
Consider me a rookie in OpenFoam. I would like to ask a basic few questions. I have read many threads but could not find an accurate answer to my doubts. I would like to carry out coning motion of an aircraft. My intention is to rotate the rigid body about the X axis at a constant Omega and get the transient results for CL, CM, CN etc.. How can I go about this problem? Which tutorials should I be focused on? Many thanks for the help in advance. Regards Shereez |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem in dynamic meshing | engrmansoor2534 | FLUENT | 0 | October 7, 2015 09:42 |
[Gmsh] Vertex numbering is dense | KateEisenhower | OpenFOAM Meshing & Mesh Conversion | 7 | August 3, 2015 10:49 |
Any advice on UDF for dynamic meshing in aircraft during flight? | deathaldaling | Mesh Generation & Pre-Processing | 0 | July 26, 2015 22:32 |
[ANSYS Meshing] Dynamic Meshing of a Valve in ANSYS FLuent 15.0 | A.Jalal | ANSYS Meshing & Geometry | 0 | March 23, 2015 18:37 |
Dynamic meshing | Manoj Kumar | FLUENT | 3 | June 27, 2010 19:26 |