store release simulation

corger · September 7, 2015, 07:41

I have written a stand-alone store release simulation computer program (Fortran) which operates in the OpenFOAM environment and calls various OpenFOAM functions (snappyHexMesh and various OpenFOAM solvers). Validation was successfully done for two sets of data: CFD Challenge II flight test data and NEAR windtunnel data. Does anyone have other store release data that I can use for validation? Probably best to email me.

corger · September 16, 2015, 03:33

Referring to my earlier post, I forgot to attach the draft document that reports on my results so far. I tried to attach it now but notice that the file size is way too large (about 1Mb). So, if you would like to obtain this document you must email me at corger@mweb.co.za . By the way, I still would appreciate any additional experimental store release data that I could include.
Regards,
Gerrit

corger · February 25, 2016, 03:28

For convenience the report can be downloaded from the link:

https://www.dropbox.com/s/7wcohifsozrgqzh/OFrelease.doc?dl=0

September 7, 2015, 07:41	store release simulation	#1
corger New Member Gerrit van den Broek Join Date: Feb 2013 Posts: 3 Rep Power: 13	I have written a stand-alone store release simulation computer program (Fortran) which operates in the OpenFOAM environment and calls various OpenFOAM functions (snappyHexMesh and various OpenFOAM solvers). Validation was successfully done for two sets of data: CFD Challenge II flight test data and NEAR windtunnel data. Does anyone have other store release data that I can use for validation? Probably best to email me.

September 16, 2015, 03:33	store release simulation - update	#2
corger New Member Gerrit van den Broek Join Date: Feb 2013 Posts: 3 Rep Power: 13	Referring to my earlier post, I forgot to attach the draft document that reports on my results so far. I tried to attach it now but notice that the file size is way too large (about 1Mb). So, if you would like to obtain this document you must email me at corger@mweb.co.za . By the way, I still would appreciate any additional experimental store release data that I could include. Regards, Gerrit

February 25, 2016, 03:28	store release simulation - report	#3
corger New Member Gerrit van den Broek Join Date: Feb 2013 Posts: 3 Rep Power: 13	For convenience the report can be downloaded from the link: https://www.dropbox.com/s/7wcohifsozrgqzh/OFrelease.doc?dl=0

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
FOAM-extend next release (release 3.2) - test phase extended to August 31st	fguibault	OpenFOAM Announcements from Other Sources	1	September 17, 2015 19:52
Simulation of high pressure diesel injector - all phases compressible with cavitation	fivos	CFX	4	July 30, 2015 06:48
Huge file sizes when Running VOF simulation	aarratia	FLUENT	0	May 8, 2014 12:27
Extend Project Release 1.6-ext	hjasak	OpenFOAM Announcements from Other Sources	33	July 14, 2011 18:54
Simulation of a complex wing in solidworks flow simulation	niels1900	FloEFD, FloWorks & FloTHERM	6	April 20, 2011 10:44