|
[Sponsors] |
July 18, 2012, 07:36 |
Mesh quality
|
#1 |
New Member
Senol
Join Date: Aug 2011
Posts: 7
Rep Power: 14 |
Hi friends,
I made a mesh that was converted from solidworks ".stl" by snappyhexmesh. The result mesh is not bad but in some points there is some unwanted meshes , how can fix it. meshFault(closer).jpgmeshFault.jpgcornerFault.jpg |
|
July 18, 2012, 09:47 |
|
#2 |
Senior Member
|
My guess is that these points are not really present in your mesh, but paraview introduces them for displaying purposes. Converting the mesh to VTK (foamToVTK) and displaying the VTK instead of the native OpenFOAM format might help with that, but I am not totally sure about that.
|
|
July 19, 2012, 07:29 |
|
#3 |
New Member
Senol
Join Date: Aug 2011
Posts: 7
Rep Power: 14 |
Firstly thank you for your reply. I guess you are right, i did what you said and the result is ok.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
Polyhedral Mesh Quality in Star-CCM+ | niazaliahmed | STAR-CCM+ | 3 | March 8, 2012 13:51 |
[ICEM] Tetra mesh quality before and after prism layer | Chander | ANSYS Meshing & Geometry | 0 | December 25, 2011 22:04 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |