[Sargam05]

Originally Posted by wyldckat

Hi Sangeeta,

OK, there are two other points you can check/test:

1. What does checkMesh tell you when you check you mesh?
   Just in case you don't know, you can check your mesh by simply running:

   checkMesh

   For more, you can:
   • Find out more commands for checkMesh:

     checkMesh -help

   • You can see an example for removing bad cells from the mesh: http://openfoamwiki.net/index.php/SetSet - although it can also be just as hazardous to simply remove the bad cells...
     Anyway, from that example you can see a couple of additional useful options for checkMesh.
2. Try with a simply 3D example, to check if your settings are good enough.

Best regards,
Bruno

Hi Bruno,

Thanks a lot for the reply. I hope this will help to solve my problem.

Regards,
Sangeeta