|
[Sponsors] |
July 10, 2013, 16:12 |
Propeller case in AMI tutorial
|
#1 |
Member
reza
Join Date: Jan 2013
Location: Goteborg-Sweden
Posts: 79
Rep Power: 13 |
Hi Foamers,
I run the propeller case in AMI tutorial oF2.1x. One odd thing is the back flow on tip of blade and the non zero velocity in y-dir (flow dir) that not satisfy the no slip condition.(Please look the attachments) I would like to know your comments. The images are as below: Last edited by wyldckat; April 30, 2017 at 11:00. Reason: merged posts done a few minutes apart |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
MRF and employing on a propeller case | reza1980 | OpenFOAM | 10 | December 23, 2017 11:29 |
A questionable Tutorial test case | immortality | OpenFOAM Running, Solving & CFD | 0 | December 5, 2012 08:40 |
propeller tutorial | openfoam_user | OpenFOAM Running, Solving & CFD | 0 | February 8, 2012 04:02 |
tutorial copying troubles / new case | Gabbee90 | OpenFOAM Running, Solving & CFD | 0 | June 3, 2011 21:50 |
FoamX refuses to open an interFoam tutorial case | vrecha | OpenFOAM Pre-Processing | 5 | March 12, 2008 12:36 |