Home > Forums > Software User Forums > OpenFOAM

quenching simulation

Mark Forums Read

Reply

Search this Thread

April 22, 2014, 17:34	quenching simulation	#1
guido.bonalumi New Member Guido Bonalumi Join Date: Dec 2013 Posts: 16 Rep Power: 14	Hi everyone, I am trying to simulate quenching of a steel bar in oil. It is a rough simulation, I do not care about phase change or boiling (at least not at the moment). I have different regions, one for the oil and the other one for the steel, so I was thinking at chtMultiRegionFoam, but is it suitable for transient simulation? Do you have any suggestion? Thanks in advance!

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Solar Radiation in OpenFOAM	plainstyle	OpenFOAM Running, Solving & CFD	15	July 8, 2014 05:43
Exporting data of transient simulation DURING a simulation, at user locations ?	Milan2013	CFX	0	April 18, 2014 04:47
Simulation of a complex wing in solidworks flow simulation	niels1900	FloEFD, FloWorks & FloTHERM	6	April 20, 2011 11:44
GUI crash and simulation engine still running	RPJones	FLOW-3D	2	November 9, 2010 09:18
Continuous vs interrupted simulation	sega	OpenFOAM Running, Solving & CFD	4	November 3, 2008 15:29

All times are GMT -4. The time now is 20:24.