|
[Sponsors] |
November 15, 2016, 06:00 |
Setup origin of the coordinate system
|
#1 |
New Member
Daniel
Join Date: Nov 2016
Posts: 2
Rep Power: 0 |
Hello ,
Is it possible to configure in OpenFOAM (blockMesh,snappyHexMesh) the origin of the coordinate system ? I would like for example to set the origin where my measuring instrument ( a radar ) is installed. Many thanks, Daniel |
|
November 15, 2016, 16:32 |
|
#2 |
Senior Member
khedar
Join Date: Oct 2016
Posts: 111
Rep Power: 9 |
While writing the blockMeshDict file, one specifies the point coordinates. You can put the radar at (0,0,0) and define all other points relative to it.
|
|
November 16, 2016, 05:07 |
|
#3 |
Senior Member
Joachim Herb
Join Date: Sep 2010
Posts: 650
Rep Power: 21 |
Or you could use transformPoints to translate your mesh in a way that your measuring instrument is at the origin.
|
|
Tags |
coordinate system, origin |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Global coordinate system and rotation-axis origin | norger | FLUENT | 8 | January 18, 2018 20:10 |
coordinate system for wheel simulation | eoiny123 | FLUENT | 0 | February 20, 2014 10:36 |
coordinate system poroussimplefoam | tehzap | OpenFOAM Pre-Processing | 0 | November 28, 2013 10:40 |
Creating a local coordinate system | lentschi | CFX | 0 | November 21, 2010 13:55 |
Coordinate of axis origin | Tang | FLUENT | 0 | October 4, 2004 16:38 |