|
[Sponsors] |
Flow rate below a bridge and overflow computation |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 14, 2018, 11:23 |
Flow rate below a bridge and overflow computation
|
#1 |
New Member
Join Date: Dec 2018
Posts: 1
Rep Power: 0 |
Hello foamers!
I'm a starter in OpenFOAM working on a project about bridge overflow. There are many ways to compute the flow rate at inlet/outlet patch and also some arbitary plane inside the mesh. But as far as I know, all those methods can only be applied to the entire cross section. Is there a way to compute the flow rate/mass flow in separated sections? Or maybe some hints on calculation of flow in two outlets (which could somehow resemble the case) ? Thanks, Lei |
|
Tags |
bridge design, flow rate, free surface flow, incompressible flow, mass flow splitting |
Thread Tools | Search this Thread |
Display Modes | |
|
|