Home > Forums > Software User Forums > OpenFOAM

AMI vs Overset Meshes

Mark Forums Read

Reply

Search this Thread

August 4, 2021, 09:38	AMI vs Overset Meshes	#1
night-hawk Member Ashutosh Join Date: Jul 2021 Location: India Posts: 75 Rep Power: 4	Hi everyone, Is there is advantage in using overset meshes over AMI e.g reduction in computational time .

Reply

Tags

amicyclic, overset mesh

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Error running AMI propeller simulation	luitzor	OpenFOAM Running, Solving & CFD	0	April 19, 2021 13:48
[swak4Foam] reconstructPar error in MRFsimpleFoam (ami apprach) using GroovyBC velocity inlet	Krao	OpenFOAM Community Contributions	3	August 19, 2019 05:40
mapField error	rvl565	OpenFOAM Pre-Processing	1	September 6, 2018 16:13
[mesh manipulation] Combining two meshes for AMI of rotating turbine	mahtin360	OpenFOAM Meshing & Mesh Conversion	0	October 2, 2014 03:06
mixerVesselAMI2D's mass is not balancing	sharonyue	OpenFOAM Running, Solving & CFD	6	June 10, 2013 09:34

All times are GMT -4. The time now is 21:42.