|
[Sponsors] |
March 21, 2023, 00:10 |
mapFields with different number of patches
|
#1 |
New Member
Abhijit
Join Date: Aug 2020
Location: India
Posts: 27
Rep Power: 5 |
I want to solve vortex-induced vibration of a cylinder in a duct. I have solved the flow in a duct without the cylinder and then I want to map the fields from the cylinder-less problem to the problem with the cylinder in a duct. Both the geometries have same dimensions. But when I tried to map the fields the error comes:
--> FOAM FATAL ERROR: Incompatible meshes: different number of patches, fromMesh = 6, toMesh = 7 I think the reason is with the cylinder case I have to add the cylinder patch. Is there anyway to map the fields with different number of patches? I have attached the two meshes: without_cylinder.jpeg with_cylinder.jpeg Thank you in advance. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
use the message in macro DEFINE_PROFILE with parallel processor | alireza_T | Fluent UDF and Scheme Programming | 3 | May 11, 2022 02:08 |
[Other] Can't Shake Erros: patch type 'patch' not constraint type 'empty' | BrendaEM | OpenFOAM Meshing & Mesh Conversion | 12 | April 3, 2022 18:32 |
[snappyHexMesh] snappyHexMesh stuck when snap is turned on | yukuns | OpenFOAM Meshing & Mesh Conversion | 3 | February 2, 2021 13:05 |
GenerateVolumeMesh Error - Surface Wrapper Self Interacting (?) | AndreP | STAR-CCM+ | 10 | August 2, 2018 07:48 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |