|
[Sponsors] |
realizableKEpsilon is very sensitive to inlet condition |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 20, 2024, 05:04 |
realizableKEpsilon is very sensitive to inlet condition
|
#1 |
Senior Member
Dongyue Li
Join Date: Jun 2012
Location: Beijing, China
Posts: 838
Rep Power: 17 |
After many test cases launched on different geometries, I found realizableKEpsilon is very sensitive to the inlet turbulence condition. You can run the pitzDaily test case by adjusting only the k inlet value. In the following 4 tests, I set them as:
kEpsilon: kInlet = 0.375 kEpsilon: kInlet = 0.0375 realizableKEpsilon: kInlet = 0.375 realizableKEpsilon: kInlet = 0.0375 You can see the first three predict almost same nut. But the last one does not.
__________________
My OpenFOAM algorithm website: http://dyfluid.com By far the largest Chinese CFD-based forum: http://www.cfd-china.com/category/6/openfoam We provide lots of clusters to Chinese customers, and we are considering to do business overseas: http://dyfluid.com/DMCmodel.html |
|
February 20, 2024, 07:25 |
|
#2 |
Senior Member
Dongyue Li
Join Date: Jun 2012
Location: Beijing, China
Posts: 838
Rep Power: 17 |
I have no idea why I cannot upload more pictures (404 forbidden), I will come back to update again.
__________________
My OpenFOAM algorithm website: http://dyfluid.com By far the largest Chinese CFD-based forum: http://www.cfd-china.com/category/6/openfoam We provide lots of clusters to Chinese customers, and we are considering to do business overseas: http://dyfluid.com/DMCmodel.html |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
totalPressure Inlet boundary condition | loewieke53 | OpenFOAM Pre-Processing | 8 | April 21, 2020 08:29 |
Turn inlet and outlet to boundary condition | matos | FLUENT | 2 | December 30, 2018 15:20 |
Total pressure and mass flow boundary condition at inlet | bscphil | OpenFOAM Pre-Processing | 3 | July 9, 2017 14:39 |
To change temperature in mass flow inlet boundary condition per iteration | ajinkya201991 | FLUENT | 1 | July 11, 2014 11:29 |
boundary condition for coupled inlet and outlet | xxxx | OpenFOAM Pre-Processing | 2 | August 13, 2013 15:51 |