 |
 |
 |
|
|
|
[Sponsors] | ||||
February 24, 2024, 01:39
|
Octree Mesh
|
#1 |
|
New Member
HS
Join Date: Sep 2022
Posts: 9
Rep Power: 3  |
Hello,
I would like to analyze a channel flow with Smagorinsky LES using OpenFOAM. But i want to do this on an octree mesh refining the upper and lower walls. Can you give any advice about how can I generate an octree mesh? Thank you in advance. Regards, Last edited by ChaldExals; February 24, 2024 at 07:44. |
|
|
|
|
|
February 24, 2024, 07:30
|
|
#2 |
|
New Member
HS
Join Date: Sep 2022
Posts: 9
Rep Power: 3 |
I tried blockMesh utility but I guess it does not work for such type of octree mesh. I found a similar mesh I want to generate. However, I don't know if OpenFOAM has a utility for this type of mesh.
Screenshot_20240224_151438_Chrome.jpg |
|
|
|
|
|
 |
| Tags |
| channel flow, les, octree, smagorinsky |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Add Mesh Layers doesnt work on the whole surface | Kryo | OpenFOAM Meshing & Mesh Conversion | 13 | February 17, 2022 07:34 |
| [snappyHexMesh] snappyHexMesh stuck when snap is turned on | yukuns | OpenFOAM Meshing & Mesh Conversion | 3 | February 2, 2021 13:05 |
| [snappyHexMesh] non uniform mesh near the stl object | vava10 | OpenFOAM Meshing & Mesh Conversion | 0 | January 31, 2021 14:41 |
| decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
| [snappyHexMesh] Layers:problem with curvature | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 10 | August 22, 2012 09:03 |
Linear Mode
