|
[Sponsors] |
March 4, 2024, 21:51 |
Nonuniform List face order
|
#1 |
New Member
Joćo Pedro
Join Date: May 2019
Posts: 4
Rep Power: 6 |
Hello everyone, im trying to use the "nonuniform List <scalar>" function to describe a non-uniform (obviously) z0 for the atmNutkWallFunction, but since im using snappyHexMesh to refine my ground patch, the "order" of the faces gets all messed up and i can't properly set my z0 information.
Can you guys give me a hint on how to solve this problem? Thanks in advance! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] mesh airfoil NACA0012 | anand_30 | OpenFOAM Meshing & Mesh Conversion | 13 | March 7, 2022 17:22 |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
[blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
[blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 07:36 |