|
[Sponsors] |
March 29, 2011, 10:35 |
Surface normal gradient on unstructured mesh
|
#1 |
Senior Member
Fumiya Nozaki
Join Date: Jun 2010
Location: Yokohama, Japan
Posts: 266
Blog Entries: 1
Rep Power: 19 |
Hi,
What is the most accurate scheme available in OpenFOAM to calculate the surface normal gradient when using unstructured meshes. Does the function wallGradU apply the non-orthogonal correction? Regards, fumiya |
|
September 30, 2011, 04:34 |
|
#2 |
Senior Member
Join Date: Nov 2009
Location: Michigan
Posts: 135
Rep Power: 16 |
Hi.
Did you get any answer? |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
Recover surface from surface mesh in IcemCFD | Jerry Tanner | CFX | 0 | August 20, 2008 12:48 |
Normal - Helical Surface | m. malik | Main CFD Forum | 3 | February 3, 2006 12:56 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |
unstructured vs. structured grids | Frank Muldoon | Main CFD Forum | 1 | January 5, 1999 10:09 |