heat transfer boussinesq

Andrev · October 13, 2011, 16:02

Dear Foam s,
please

can anyone tell me how can I set a fixed heat flux on a wall using buoyantBoussinesqPimpleFoam?

On the temperature file (T and T.org), if I set temperature as a fixedGradient, does it works?

like grad (T) = qflux / k.

Thanks for the attention.

nimasam · October 15, 2011, 10:10

it depends ur k is fixed or not
1) if your k is fixed so use the fix Gradient for temperature

2) if your k is variable and change during simulation use groovyBC, to read k in each simulation and divide it into fixed qflux. (you can find in froum more

)

Andrev · October 18, 2011, 17:30

Thanks for the help.

I'm having problems with the time step of my case,
when I set a fixedGradient to define heat flux ( k constant), if I increase the time step on controlDict, the results change too: temperature increases...

Anyone know what am I doing wrong ?

Thanks for the attention.

October 13, 2011, 16:02	heat transfer boussinesq	#1
Andrev New Member AV. Join Date: Apr 2011 Posts: 14 Rep Power: 16	Dear Foam s, please can anyone tell me how can I set a fixed heat flux on a wall using buoyantBoussinesqPimpleFoam? On the temperature file (T and T.org), if I set temperature as a fixedGradient, does it works? like grad (T) = qflux / k. Thanks for the attention.

October 15, 2011, 10:10		#2
nimasam Senior Member Nima Samkhaniani Join Date: Sep 2009 Location: Tehran, Iran Posts: 1,269 Blog Entries: 1 Rep Power: 26	it depends ur k is fixed or not 1) if your k is fixed so use the fix Gradient for temperature 2) if your k is variable and change during simulation use groovyBC, to read k in each simulation and divide it into fixed qflux. (you can find in froum more ) Andrev likes this.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Two-sided Wall Heat Transfer BC - No Separate Solid Mesh and No Heat Transfer Coeff	swahono	OpenFOAM Running, Solving & CFD	10	October 15, 2018 06:43
Water subcooled boiling	Attesz	CFX	7	January 5, 2013 04:32
Convective / Conductive Heat Transfer in Hypersonic flows	enigma	Main CFD Forum	2	November 1, 2009 23:53
How can I increase Heat Transfer at Domain Interf?	B.Simon	CFX	3	October 28, 2008 19:53
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 16:55

October 18, 2011, 17:30		#3
Andrev New Member AV. Join Date: Apr 2011 Posts: 14 Rep Power: 16	Thanks for the help. I'm having problems with the time step of my case, when I set a fixedGradient to define heat flux ( k constant), if I increase the time step on controlDict, the results change too: temperature increases... Anyone know what am I doing wrong ? Thanks for the attention.