[General] Issue in aspect of two equal surfaces -- CFD Online Discussion Forums

December 4, 2015, 03:15	Issue in aspect of two equal surfaces	#1
cfdFreshman New Member Join Date: Nov 2015 Location: GER Posts: 10 Rep Power: 10	Hello again, I would like to visualize a geometry and its fill as slice. The uncomely thing about this is, that the surfaces are of course the same. So ParaView tries to show both of them which means that the geometry has some block size overlappings of the fill. Is it possible to force the geometry to be shown or maybe shrink the fill a little? Regards, cfdFreshman

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to get two sided surfaces	sebbel	CFX	1	November 16, 2018 02:45
NURBS surfaces on a wing	frossi	CFX	5	February 5, 2017 15:27
Specifying points for sampling surfaces in sampleDict	arieljeds	OpenFOAM Post-Processing	0	April 20, 2016 07:11
[ICEM] Issue creating geometry and trim surfaces	M4x1m	ANSYS Meshing & Geometry	1	February 9, 2015 08:38
Normal vector, slope and aspect angle	g_niro	Main CFD Forum	0	February 2, 2011 17:24

All times are GMT -4. The time now is 20:06.