[Bazinga]

Dear all,

I have two problems using ParaView that i could not really solve, even after using the search function here and trying some filters on my own.

1. I want to compare my CFD results with results from wind tunnel measurements. My plan is to import the measurement points into Paraview using a *.csv file and output the flow values at those points for further post processing. I used the table to points filter, but I was not able to get any flow values displayed on those points.

Can somebody explain a procedure that works here?

2. I need the cell size of the mesh for a verification method. Is there a way to output the cell size over a line for example using ParaView?