[General] How to convert DEM point data to cell data form? -- CFD Online Discussion Forums

June 26, 2020, 18:07	How to convert DEM point data to cell data form?	#1
Moha Sobhi New Member Mohamed Sobhi Join Date: Sep 2017 Posts: 4 Rep Power: 8	Hello everyone! I have a DEM case that contains two solid particles and I would like to have the results in cell data form (e.g., void fraction, velocity, …etc) instead of the default DEM output (point data “Diameter, Velocity”). I tried using ParaView filter “point to cell data”, but it didn’t work. Maybe, I did something no correct, because I am not expert in the Paraview. I appreciate it if somebody can give me good directions! Mohamed

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[General] what is difference between point data and cell data?	kyurinPark	ParaView	1	June 19, 2018 18:49
CFD by anderson, chp 10.... supersonic flow over flat plate	varunjain89	Main CFD Forum	18	May 11, 2018 07:31
[blockMesh] error EOF in blockMesh	Ahmed Khattab	OpenFOAM Meshing & Mesh Conversion	7	May 17, 2012 00:37
Cells with t below lower limit	Purushothama	Siemens	2	May 31, 2010 21:58
CFX4.3 -build analysis form	Chie Min	CFX	5	July 12, 2001 23:19

All times are GMT -4. The time now is 08:47.