|
[Sponsors] |
April 20, 2017, 06:59 |
ParaView flow rate
|
#1 |
New Member
Eimantas
Join Date: Apr 2017
Posts: 1
Rep Power: 0 |
Hey all,
I have a simple stream of water flowing in the -z direction, and would simply like to find out the total flow rate across its area. The file is is .vtk and I have seen some people write about using the surface flows feature, however I am not sure how to make this work. I have also seen some people write about using the calculator filter and obtaining the vel_z values, but again, I am not sure how to define an area for after that step. Any help would be greatly appreciated. Thank you in advance. Eiman |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Specify mass flow rate for periodic boundary conditions in channel flow | lion1990 | OpenFOAM Running, Solving & CFD | 1 | July 9, 2018 17:46 |
Iteration number - flow rate relation | helvas | CFX | 6 | May 30, 2016 02:57 |
Mass flow rate boundary condition with negative values | ashtonJ | CFX | 3 | November 26, 2014 05:21 |
[General] ParaView Mass Flow Rate | jotter | ParaView | 0 | December 10, 2012 16:49 |
[OpenFOAM] Mass flow rate with Paraview 330 | marta_colomer | ParaView | 2 | October 14, 2008 10:27 |