|
[Sponsors] |
[General] How to convert DEM point data to cell data form? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 26, 2020, 18:07 |
How to convert DEM point data to cell data form?
|
#1 |
New Member
Mohamed Sobhi
Join Date: Sep 2017
Posts: 4
Rep Power: 8 |
Hello everyone!
I have a DEM case that contains two solid particles and I would like to have the results in cell data form (e.g., void fraction, velocity, …etc) instead of the default DEM output (point data “Diameter, Velocity”). I tried using ParaView filter “point to cell data”, but it didn’t work. Maybe, I did something no correct, because I am not expert in the Paraview. I appreciate it if somebody can give me good directions! Mohamed |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[General] what is difference between point data and cell data? | kyurinPark | ParaView | 1 | June 19, 2018 18:49 |
CFD by anderson, chp 10.... supersonic flow over flat plate | varunjain89 | Main CFD Forum | 18 | May 11, 2018 07:31 |
[blockMesh] error EOF in blockMesh | Ahmed Khattab | OpenFOAM Meshing & Mesh Conversion | 7 | May 17, 2012 00:37 |
Cells with t below lower limit | Purushothama | Siemens | 2 | May 31, 2010 21:58 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |