Home > Forums > Visualization & Post-Processing Software > ParaView

[General] post processing vtk files of pump

Mark Forums Read

Reply

Search this Thread

October 11, 2020, 15:36	post processing vtk files of pump	#1
Ali_pirkhalili New Member Ali Pirkhalili Join Date: Oct 2020 Posts: 1 Rep Power: 0	Hello every body I've simulated a centrifugal pump as Case Pump in Dual SPHysics software. After a complete run, I should take vtk files of pump into ParaView for post processing. How can I get, for example, the H-Q diagram of the pump? Rigards

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
CFX Post: .trn files bunching?	user_of_cfx	CFX	9	December 3, 2015 04:48
UDF issue	MASOUD	Fluent UDF and Scheme Programming	14	December 6, 2012 13:39
Ansys Post processing	ano999	ANSYS	1	May 27, 2011 16:24
critical error during installation of openfoam	Fabio88	OpenFOAM Installation	21	June 2, 2010 03:01
OF 1.6 \| Ubuntu 9.10 (64bit) \| GLIBCXX_3.4.11 not found	piprus	OpenFOAM Installation	22	February 25, 2010 13:43

All times are GMT -4. The time now is 18:11.