|
[Sponsors] |
October 11, 2020, 15:36 |
post processing vtk files of pump
|
#1 |
New Member
Ali Pirkhalili
Join Date: Oct 2020
Posts: 1
Rep Power: 0 |
Hello every body
I've simulated a centrifugal pump as Case Pump in Dual SPHysics software. After a complete run, I should take vtk files of pump into ParaView for post processing. How can I get, for example, the H-Q diagram of the pump? Rigards |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CFX Post: .trn files bunching? | user_of_cfx | CFX | 9 | December 3, 2015 04:48 |
UDF issue | MASOUD | Fluent UDF and Scheme Programming | 14 | December 6, 2012 13:39 |
Ansys Post processing | ano999 | ANSYS | 1 | May 27, 2011 16:24 |
critical error during installation of openfoam | Fabio88 | OpenFOAM Installation | 21 | June 2, 2010 03:01 |
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 13:43 |