[OpenFOAM] paraview simple quesions

preibie · June 22, 2009, 05:18

Hallo,

I used paraview since a view month and I have two questions simple questions:

1: I had made a simulation with 3 Million cells I want to look to the results with paraview. When I look normal to a slice all is fine but when I look normal I see the grit. How can I switch the grid off. ( I only have an active slice)

2: How it is possible to write Greek-symbol like a Delta in the legend?

Thanks for helping me

Preibie

anon_r · June 26, 2009, 09:34

answer to 2.: afterwards, in "PAINT"

preibie · June 29, 2009, 05:15

good joke!!

Is there no possibility to chose Greek symbols in paraview?

Give it an other (better) open source post processing tool?

June 22, 2009, 05:18	paraview simple quesions	#1
preibie Member Stefan Join Date: Jun 2009 Posts: 67 Rep Power: 17	Hallo, I used paraview since a view month and I have two questions simple questions: 1: I had made a simulation with 3 Million cells I want to look to the results with paraview. When I look normal to a slice all is fine but when I look normal I see the grit. How can I switch the grid off. ( I only have an active slice) 2: How it is possible to write Greek-symbol like a Delta in the legend? Thanks for helping me Preibie

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[OpenFOAM.org] Paraview 5.4 in shell environment of5x - Segmentation fault (core dumped)	dslbkxd	OpenFOAM Installation	1	February 3, 2018 00:56
Error: Comparing the result of DTCHullWaves with two different ParaView version	ali.ikhsanul	OpenFOAM	0	December 11, 2017 05:17
[OpenFOAM.org] Two different versions of ParaView with same OpenFOAM release	FJSJ	OpenFOAM Installation	2	July 23, 2017 05:48
[General] Paraview nice animation	PyGloo	ParaView	4	June 7, 2012 12:34
Paraview installation troubles	jjhall	OpenFOAM Installation	3	April 17, 2008 12:59

June 26, 2009, 09:34		#2
anon_r Disabled Join Date: Mar 2009 Posts: 136 Rep Power: 22	answer to 2.: afterwards, in "PAINT"

June 29, 2009, 05:15		#3
preibie Member Stefan Join Date: Jun 2009 Posts: 67 Rep Power: 17	good joke!! Is there no possibility to chose Greek symbols in paraview? Give it an other (better) open source post processing tool?