|
[Sponsors] |
February 1, 2011, 10:48 |
Visualizing in Paraview
|
#1 |
New Member
Join Date: Feb 2011
Posts: 3
Rep Power: 15 |
Hello,
I'm fairly new at visualizing 3D data in Paraview and I want to ask a small question: I have a 3D surface which I have imported of size 1300*600*300. When I want to move around the sample in the 3D-view, it resamples it using the LOD. But every time I release the mouse button or change parameters or it renders the surface. This is very annoying and time consuming since the rendering each time takes aroud one minute. Is there any way that you can always look at the resampled LOD-view and manually render the surface whenever you want (after you have found the right camera angle and changed all parameters). thanks Tomas |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[OpenFOAM] Visualizing faces of an OpenFOAM mesh by ID in Paraview | Timm Feigel | ParaView | 3 | April 30, 2020 05:19 |
[General] Problem visualizing parallel data in ParaView | fluent-user | ParaView | 1 | May 26, 2016 18:56 |
[OpenFOAM] paraview visualizing error for openFoam results | ahmed_khatibs | ParaView | 0 | September 17, 2012 01:35 |
Segmentation fault when visualizing in ParaView | fsalvucci | OpenFOAM | 9 | July 30, 2010 15:39 |
paraFoam reader for OpenFOAM 1.6 | smart | OpenFOAM Installation | 13 | November 16, 2009 21:41 |