 |
 |
 |
|
|
|
[Sponsors] | ||||
[General] Create surface from points in Paraview |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 12, 2011, 12:10
|
Create surface from points in Paraview
|
#1 |
|
Member
Join Date: Sep 2010
Posts: 30
Rep Power: 17  |
Hi everyone,
From discrete points, i d like to create a surface. The points are defined on this example at each floor of my building. Is it possible to create a surface for each floor without splitting each surface and applying a Delaunay-2D ? For example by giving a criteria of length of the closest neighboor point to create a surface , for example the surface can not be created for points with distance > 2 m. Thanks in advance G. |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] snappyHexMesh can't create refimenet region | clktp | OpenFOAM Meshing & Mesh Conversion | 3 | February 27, 2022 10:26 |
| [snappyHexMesh] SHM doesn't create cellZones for one region | Eko | OpenFOAM Meshing & Mesh Conversion | 10 | January 24, 2018 03:03 |
| Cluster ID's not contiguous in compute-nodes domain. ??? | Shogan | FLUENT | 1 | May 28, 2014 16:03 |
| [DesignModeler] Design Modeller create surface | papis | ANSYS Meshing & Geometry | 0 | October 31, 2013 14:52 |
| Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 02:07 |
Linear Mode
