 |
 |
 |
|
|
|
[Sponsors] | ||||
May 31, 2013, 06:46
|
Extrude Normal Problem
|
#1 |
|
New Member
Tomas
Join Date: May 2013
Posts: 5
Rep Power: 14  |
Dear all,
I'm new with pointwise and I'm doing the meshing of a foil and the mesh is growing inside and outside of the curve shown in the pic 1 and 2. Maybe this is because the growing arrows of the pic 3 didnt apear in my case. Also how to face the problem with 2 foils like in the pic 4?? |
|
|
|
|
|
May 31, 2013, 12:36
|
|
#2 |
|
New Member
James
Join Date: Oct 2012
Posts: 18
Rep Power: 15 |
Tomas,
You can try to find the answer to your problem in previous threads for instance: http://www.cfd-online.com/Forums/poi...g-surface.html http://www.cfd-online.com/Forums/poi...extrusion.html http://www.cfd-online.com/Forums/poi...ayer-mesh.html If the airfoil has the same cross section on both sides you can create 2D mesh and then use the path based extrusion. |
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] Handling cyclic BC from gambit to openfoam for a cascade airfoil problem - OF 1.6 | maverick | OpenFOAM Meshing & Mesh Conversion | 2 | June 18, 2011 05:36 |
| Can I solve this problem by Fluent? | Kai_kc | FLUENT | 1 | October 27, 2010 06:29 |
| Velocity profiles problem behind the elbow (3D problem) | kabat73 | FLUENT | 8 | May 9, 2010 05:26 |
| Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 20:13 |
| How to extrude 2D Mesh in ICEM CFD? | VSB | CFX | 7 | December 27, 2006 12:58 |
Linear Mode
