|
[Sponsors] |
September 9, 2013, 09:34 |
Problem Creating Models by joining Quilts..
|
#1 |
New Member
Sulman Aziz
Join Date: May 2012
Posts: 8
Rep Power: 13 |
Hi , I am trying to mesh a geometry imported in Gridgen in .igs format. and i m facing a lot of difficulties.
1. there are multiple edges appeared in geometry against each edge. 2. i followed the tutorial of meshing of DLR-F6 and did it up to quilts. and after that couldn't make solid models. kindly suggest me what to do..? i m stuck here.. with best regards Sulman Aziz |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Eddy Viscosity Models and Reynolds Stress Models | JuPa | CFX | 1 | August 20, 2013 18:56 |
[ICEM] Creating a prism layer causes problem.. | earth07 | ANSYS Meshing & Geometry | 1 | June 3, 2013 10:28 |
Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 05:59 |
Reynolds transport, turbulence model, etc | Beginner | Main CFD Forum | 1 | January 7, 2009 05:36 |
Problem in creating .geo file | SHABAH | CFX | 13 | April 25, 2001 02:22 |