|
[Sponsors] |
September 9, 2014, 10:03 |
3D T-rex: Problem Initializing Block
|
#1 |
New Member
Cameron
Join Date: Sep 2014
Posts: 2
Rep Power: 0 |
I'm currently trying to model flow over an iced airfoil. However, every time I try to T-rex my block, it goes through however iterations I specify for "Max layers" and then gives the error "could not import tets." Any idea what Might be going wrong? Details on my mesh are below.
I'm modeling a NACA0012 with a horn ice shape in a wind tunnel. I'm using two baffle surfaces behind the ice shape to increase resolution in the separation bubble region. These baffle faces are set to "off" boundary conditions. I also have T-rexed both the inlet and outlet surfaces in 2D prior to assembling the block. Below is a picture of the airfoil. https://app.box.com/s/23jaxhwsldypigzf34yq |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem in initializing transient simulation with a finer mesh | sidd | CFX | 8 | April 29, 2016 02:25 |
T-Rex block next to structured block | Aeronautics El. K. | Pointwise & Gridgen | 7 | August 10, 2014 07:42 |
[Commercial meshers] Icem Mesh to Foam | jphandrigan | OpenFOAM Meshing & Mesh Conversion | 4 | March 9, 2010 02:58 |
Initializing different block in 3D | star123 | FLUENT | 1 | April 8, 2008 20:57 |
problem in initializing the flow for supersonic | jon william | FLUENT | 0 | October 30, 2006 08:16 |