Creating a hybrid mesh for a 2D wing

daldry · August 7, 2017, 09:12

Hi,
What is the best method to have such mesh?

deyaa.nabil · August 8, 2017, 09:13

بسم الله الرحمن الرحيم

What did you mean by tetrahedral cells around the trailing edge ?

If you mean the rear upper and lower small connectors illustrated on the attached figure

I advice you to split the full domain with a vertical line or extrude only the upper and lower structured part and select the BC to be constant x ,which achieves the splitting between quadrilateral and tetrahedral elements.

else if you mean TE point ,when using T-Rex
selecting full layer = 0 --> multiple normal will starting from TE
selecting full layer = 1 --> single normal will starting from TE

Try all and show what is the highest minimum included angle

All praise is due to Allah

best wishes

daldry · August 8, 2017, 16:47

Thank you for the reply.

The issue is ,when I create a block using the farfield domains and the wing's walls, then try to initialize the block using T-REX, it doesn't work, I can see the extrusion working, till everything around the wing is red, then an error message says that the entity couldn't be initilized.

August 7, 2017, 09:12	Creating a hybrid mesh for a 2D wing	#1
daldry New Member Join Date: Feb 2013 Posts: 8 Rep Power: 14	Hi, What is the best method to have such mesh? Last edited by daldry; August 17, 2017 at 06:44.

August 8, 2017, 09:13	To wards the best , God with the patient	#2
deyaa.nabil New Member AboAhmad Join Date: Jul 2014 Location: DSCU Posts: 7 Rep Power: 13	بسم الله الرحمن الرحيم What did you mean by tetrahedral cells around the trailing edge ? If you mean the rear upper and lower small connectors illustrated on the attached figure I advice you to split the full domain with a vertical line or extrude only the upper and lower structured part and select the BC to be constant x ,which achieves the splitting between quadrilateral and tetrahedral elements. else if you mean TE point ,when using T-Rex selecting full layer = 0 --> multiple normal will starting from TE selecting full layer = 1 --> single normal will starting from TE Try all and show what is the highest minimum included angle All praise is due to Allah best wishes daldry likes this.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Ffd_control_point_2d	feiyi	SU2	4	September 30, 2019 13:42
[ICEM] 2D hybrid mesh (unstructured mesh highly dependent on structured mesh parameters)	shubham jain	ANSYS Meshing & Geometry	1	April 10, 2017 06:03
3D Hybrid Mesh Errors	DarrenC	ANSYS Meshing & Geometry	11	August 5, 2013 07:42
mesh missing after export in gambit	morteza08	Main CFD Forum	0	July 23, 2010 03:19
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 12:55

August 8, 2017, 16:47		#3
daldry New Member Join Date: Feb 2013 Posts: 8 Rep Power: 14	Thank you for the reply. The issue is ,when I create a block using the farfield domains and the wing's walls, then try to initialize the block using T-REX, it doesn't work, I can see the extrusion working, till everything around the wing is red, then an error message says that the entity couldn't be initilized.