|
[Sponsors] |
SU2 or CGNS grid - Sources are not listed as Unspecified in final generated mesh |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 16, 2020, 12:51 |
SU2 or CGNS grid - Sources are not listed as Unspecified in final generated mesh
|
#1 |
New Member
Mons
Join Date: May 2019
Posts: 21
Rep Power: 7 |
I am trying to make source at exit of nozzle to capture finer shear layer area as seen in attached images. And I see sources does that job like creating vortx or shear layer refinement. I am trying the same but seems like when I do export into either .SU2 or .CGNS in both cases it says unspecified markers whereas I dont have unspecified markers in my boundary conditions when I did it as attached in images. So do we need to anything specific to these sources which is missing here? Appreciate your help
I am trying to refine my Shear layer starting at the exit of nozzle. Appreciate your thoughts if there is any other way to make this area refiner (rather creating connections and doing them, which I can., but there must be smarter way). Thank you for your help! |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Suppress twoPhaseEulerFoam energy | AlmostSurelyRob | OpenFOAM Running, Solving & CFD | 33 | September 25, 2018 18:45 |
[mesh manipulation] Importing Multiple Meshes | thomasnwalshiii | OpenFOAM Meshing & Mesh Conversion | 18 | December 19, 2015 19:57 |
Cannot run the code properly: very large time step continuity error | crst15 | OpenFOAM Running, Solving & CFD | 9 | December 14, 2014 19:17 |
SLTS+rhoPisoFoam: what is rDeltaT??? | nileshjrane | OpenFOAM Running, Solving & CFD | 4 | February 25, 2013 05:13 |
Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 06:24 |