|
[Sponsors] |
August 2, 2010, 09:25 |
Propeller Meshing in Gridgen/Pointwise
|
#1 |
New Member
Semih Önel
Join Date: Jun 2010
Location: İstanbul
Posts: 3
Rep Power: 15 |
Hi everyone,
I'm a new user on gridgen and pointwise, trying to mesh the propeller. As seen in the picture that I have just attached; there are three different domain volumes. Firstly, I meshed the propeller surface, after that while meshing the volume2, gridgen ignored the propeller mesh and it meshed straight through from one surface of volume2 the other one. Thanks. Last edited by ctrlaltdel; August 2, 2010 at 11:11. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
3d meshing strategy for propeller in gambit | Harikrishna | FLUENT | 3 | January 12, 2012 06:38 |
propeller blade meshing | Terence | Fidelity CFD | 8 | July 15, 2008 13:31 |
Gambit & Propeller Meshing | James Date | FLUENT | 7 | July 6, 2004 16:54 |
Meshing a Propeller | K.C | CFX | 1 | October 22, 2003 18:20 |
Singularity of grid?Volume meshing vs face meshing | Ken | Main CFD Forum | 0 | September 4, 2003 11:09 |